-Y prefabricated stainless steel chimney is mainly used for boilers, generators, cold, water heaters, incinerators, air conditioning, direct combustion unit flue gas emissions. Prefabricated stainless steel chimneys are produced in strict accordance with national standard GB GB50051-2002 "chimney design specifications, reliable quality, wide range of uses. Can be applied to a variety of boilers, direct fired units and cold water heater, such as exhaust systems and diesel generator sets, burning furnace exhaust system and air conditioning systems industrial PLAMET system exhaust emission systems. It is not only weight than traditional chimney light 1/2 the price than the traditional chimney save 1/3. 
 Enter the market, that is, by design units and construction of all ages. This product is the modular structure of the split, according to the design and construction requirements, the production into any trend. Its material is SUS304 (OCr19Ni9), SUS316 (OCr17Ni14Mo2) stainless steel, can withstand the pressure of 0.15MPa of emissions from the medium temperature up to 800 ℃. Assembly in the chimney of each component inside and outside the tube, and insulation materials before leaving the factory as a whole, on-site installation, simply tighten the screws can be, no site welding, riveting, convenient, fast installation. Have the following characteristics: high temperature: according to the general boiler flue gas temperature <240 degrees, you can also set diesel generator set to 480 ° C -680 ° C high temperature, different properties of the high-pressure mineral wool, aluminum silicate, etc., of different thickness insulation materials, to ensure that the chimney outer wall of not more than 45 degrees (thermal specifications <60 degrees). Advanced connection technology: the introduction of the TFD process, saving valuable building space occupied by the traditional flange connection process, greatly improve building space utilization efficiency, to meet the conditions of the installation of the narrow shaft; advanced technology, reasonable structure, process stability, reliable; quality and long service life (expected 50 years) and usually do not need maintenance and repair; light weight, and stent combination of scientific and rational, and the site easy to install, quick; can greatly reduce labor intensity and lower installation costs. Ease of Installation: the difficult and complex process of fabrication and installation in a narrow shaft inside the high-altitude, workshop production, forming, transported to the site combination of installation, not only to simplify the installation process, but to ensure that the liner, insulation, shell and many link in the production of quality problems. At the same time, on-site combination installation made easy. The appearance of burnished crisp, not only can be used as the point of the mural chimney cease construction of the facade, and can reduce the value of the construction area due to the built-in chimney shaft possession. 
 This product is light weight, corrosion-resistant, long life, good thermal insulation effect, elegant appearance and simple installation. Can be built-in use, but also can be attached to the wall use, you can also use as a stand-alone chimney. Is the ideal product to replace the traditional cement chimney steel chimney.